Release notes for the IAR C-SPY I-jet and JTAGjet driver

SWO features are available also for devices without SWO

This is to allow power debugging even when the device doesn't support SWO. Internally in C-SPY, power samples are delivered over the same interface as SWO data, and are treated as pseudo-SWO packets.

THUMB breakpoints that end up in the same 32-bit word are now handled correctly by C-SPY.
[EW23243]
When debugging on an AM1808 device with I-jet you no longer get warnings about misplaced SFRs.
[EW23289]
In EWARM 6.40.5:
I-jet now works with TMS470R1B1M.
[EW23310]
In EWARM 6.40.5:
C-SPY no longer terminates unexpectedly when closing a debug session.
[EW23370, EW23531]
In EWARM 6.40.5:
I-jet now works with LPC2138. Note, reset strategy must be set to "Hardware" or "Software".
[EW23427, EW23442, EW23443]
In EWARM 6.40.5:
Turning on "Power Sampling" in the Function Profiler window could sometimes cause a crash, e.g. if Profiling was turned on already when launching a debug session, but Power Sampling was turned on later. This has been fixed.
[EW23509]
In EWARM 6.40.5:
Creating or editing configurations in the Memory Configuration dialog box when running a session in Japanese could cause IAR Embedded Workbench to exit unexpectedly. This has been corrected.
[EW23513]
In EWARM 6.40.5:
I-jet now works with LPC2378. Note, reset strategy must be set to "Hardware" or "Software" and JTAG/SWD speed must be set to "Adaptive".
[EW23515]

Program corrections

New features

Release notes for the IAR C-SPY I-jet and JTAGjet driver version 6.40.5